Vaping Coil Winding Jig Tool - Type A
The Vaping Coil Winding Jig Tool is a handy little pocket device that makes wrapping coils simple and consistent every time.
Simply remove one of the wrapping posts from the internal compartment, insert it into the top hole and tighten the set screw. Wrap one end of your coil wire around the lower set screw and tighten it. Then simply begin wrapping your coil around the wrapping post until it has as many wraps as you require. When you're done, snip the ends and remove it from the wrapping post. You can also remove the wrapping post with the coil still on it and use it as a stabilization tool to attach it to your rebuildable atomizer.
The three included wrapping posts are: 1/16", 3/32", and 1/8" in size. The set screw hole will accept up to 9/64" if you want to make your own larger rods.
The device also doubles as an atomizer stand since it has a 510 threaded hole in the center.
Please do not torch your coils while they are still attached to the jig body. The set screws are nylon and will melt. Also do not over tighten the set screws or you may strip them.
Kanthal wire is not included.
Vaping Coil Winding Jig Tool - TypeA Specs:
- 1 x Vaping Coil Winding Jig Tool - TypeA
- 5 x Winding Rods